Author: Smokey
Subject: First Indication of a PPU Case Head Separation
Posted: February 20 2023 at 3:30pm
I like to start out with unfired brass. I use a very mild load, just enough to swell the case to the chamber. I also commit an unspeakable act with those loads, I grease them. The entire case slides back up against the bolt face with no stretching. After I clean off the grease. The cases are then used as a wildcat cartridge setting the resizer so as not to set the shoulder back. I also use a LEE collet die much of the time.
Subject: First Indication of a PPU Case Head Separation
Posted: February 20 2023 at 3:30pm
I like to start out with unfired brass. I use a very mild load, just enough to swell the case to the chamber. I also commit an unspeakable act with those loads, I grease them. The entire case slides back up against the bolt face with no stretching. After I clean off the grease. The cases are then used as a wildcat cartridge setting the resizer so as not to set the shoulder back. I also use a LEE collet die much of the time.