Author: britrifles
Subject: Berdan to Boxer
Posted: January 21 2024 at 5:37am
Here is my setup for pressing the aluminum bushings into the Berdan primer pockets.
![]()
Subject: Berdan to Boxer
Posted: January 21 2024 at 5:37am
Here is my setup for pressing the aluminum bushings into the Berdan primer pockets.
LE Wilson .303 Case gage, supports the case at the shoulder. Note that the case head sits above the gage as these are partial length sized cases to fit the chamber, not full length sized.
K&M Arbor Press pushes the bushing into the primer pocket. The bushing protrudes by a few thousands of an inch (case on the right), this gets trimmed off square to the case body with a LE Wilson case trimmer, with the head against the cutter.
