Author: DairyFarmer
Subject: Resizing cases for my Lithgow.
Posted: April 06 2015 at 10:12pm
To check if the die or press is not aligned correctly is a simple process.
Subject: Resizing cases for my Lithgow.
Posted: April 06 2015 at 10:12pm
To check if the die or press is not aligned correctly is a simple process.
Resize the case but don't remove it from the press.
Turn the case a third of a turn and resize again.
Turn the case a third of a turn and resize again.
Trim the case and then try and chamber it.
If the case cycles perfectly then you have found the problem / solution.
BTW I use the same technic to seat bullets. I run them through the press 3 times. Gives a nice straight round.