Author: evanguy
Subject: fire former
Posted: December 08 2015 at 2:30pm
i wouldn't say i have gone though any trouble, i personally dont have a 410 hand/long gun to form the cases with, and this was made at work with free material and i was paid during the time of making it. i guess i could have sat around and read the news paper if i wanted to have a bad day lol.
i know the method of forming cases, i plan on using 8gr w231 and cream of wheat. hot glue in the end with fully annealed cases. ill use my lathe and a nylon split bushing for drilling/reaming the primer hole to accept 209 primers.
the only crappy part is having to tighten the four bolts and loosen them back off. i may make a short barrel that threads into a lee enfield no1 receiver and use that to fire form the cases, just because its way faster to operate the bolt then those bolts
now making my own rods and pistons for my d16y8 engine was alot of trouble to save 800$ lol, next time ill buy the rods and pistons
dude i make sooo much crap hahah i have the habit of making it when board at work opposed to buying it.
im not sure if you noticed but ill also be making the 410 i fire these out of.
Subject: fire former
Posted: December 08 2015 at 2:30pm
i wouldn't say i have gone though any trouble, i personally dont have a 410 hand/long gun to form the cases with, and this was made at work with free material and i was paid during the time of making it. i guess i could have sat around and read the news paper if i wanted to have a bad day lol.
i know the method of forming cases, i plan on using 8gr w231 and cream of wheat. hot glue in the end with fully annealed cases. ill use my lathe and a nylon split bushing for drilling/reaming the primer hole to accept 209 primers.
the only crappy part is having to tighten the four bolts and loosen them back off. i may make a short barrel that threads into a lee enfield no1 receiver and use that to fire form the cases, just because its way faster to operate the bolt then those bolts
now making my own rods and pistons for my d16y8 engine was alot of trouble to save 800$ lol, next time ill buy the rods and pistons
dude i make sooo much crap hahah i have the habit of making it when board at work opposed to buying it.
im not sure if you noticed but ill also be making the 410 i fire these out of.