Author: DairyFarmer
Subject: Temp and RH
Posted: June 28 2016 at 8:08pm
Influence of Environmental Conditions on different Reload Propellants for the same calibrehttp://www.somchemreload.com/news/2014/09/16/influence-environmental-conditions-different-reload-propellants-same-calibre
Subject: Temp and RH
Posted: June 28 2016 at 8:08pm
Very interesting graphs on the Somchem site regarding reloading, the relative humidity, type of powder and temperature.
I don't think any of use would be loading where the RH is below 30%, but this could cause pressure to exceed maximum safety specs when using single base extrude powders. Maybe if you are running a heater?
