Author: Shamu
Subject: YUUUUGE changes in POI!
Posted: November 05 2017 at 2:09pm
I'm thinking of grabbing a spare rear on E-Pay & doing that. That way if I decide to do something daft, like removing the P-H I can revert easily.
I don't know if they're available there but the best mod was the LED strip-lights! They're for "jazzing up a car" & work on 12 DCV! They are self adhesive & you can cut them every 3rd bulb, (Its marked with a scissors even!) The 8X "AA" battery box is the white / clear thingy (a 3.5" floppy carrier) in the background with a 35mm slide box top as an "extra accessory" tray.
![]()
![Wink]( "Wink")
The early powder dispensers I do the double spring thing, but the later "Fail Safe" (although bloody annoying) snaps back fine as its a positive push-pull system.
I also have a couple of super strong magnets on the flip-flop primer catcher chute, but I'm not sure how you'd do that with a 650.
![Confused]( "Confused")
The POI change is ammo related, I switched back & the patterns returned & were back in the original position too. Luckily with the P-H I can just dial it back in or out as needed. I'm still not used to removing the arm to pull the bolt for cleaning then just fling it back in again afterwards, but it seems to work!
![Wacko]( "Wacko")
Subject: YUUUUGE changes in POI!
Posted: November 05 2017 at 2:09pm
I'm thinking of grabbing a spare rear on E-Pay & doing that. That way if I decide to do something daft, like removing the P-H I can revert easily.
I don't know if they're available there but the best mod was the LED strip-lights! They're for "jazzing up a car" & work on 12 DCV! They are self adhesive & you can cut them every 3rd bulb, (Its marked with a scissors even!) The 8X "AA" battery box is the white / clear thingy (a 3.5" floppy carrier) in the background with a 35mm slide box top as an "extra accessory" tray.
The early powder dispensers I do the double spring thing, but the later "Fail Safe" (although bloody annoying) snaps back fine as its a positive push-pull system.
I also have a couple of super strong magnets on the flip-flop primer catcher chute, but I'm not sure how you'd do that with a 650.
The POI change is ammo related, I switched back & the patterns returned & were back in the original position too. Luckily with the P-H I can just dial it back in or out as needed. I'm still not used to removing the arm to pull the bolt for cleaning then just fling it back in again afterwards, but it seems to work!
